The X-Board is an innovative clip-on fender with rubber fasteners for downtube mounting. - Adjustable soft rubber cable-spacers, ideal to adapt on almost any tube profile - Robust rubber fasteners - Dual compound-softspoiler
Mudguard set for front and rear. – 53mm with fixed bridges – 3mm stainless steel stays – Front angle, sliding bridges, and fixed bridges made from stainless steel – Security fastening ASR joint, angle adjustable
The S-Guard is not just for road bike cyclists; this super-lightweight (24g) and small mudguard protects your bottom from mud and water. Made with super-soft material, it fits on nearly every saddle with the addition of a cable tie.
The VELOFLEXX mudguard set combines the stability of a fixed mudguard with the flexibility of a clip-on mudguard. The VELOFLEXX bridge allows the rear mudguard to be attached at the top of the seat stay with the use of rubber straps—no tools needed. This method of mounting doesn't rely on the cross stay where the caliper brake is usually bolted. At the front, the VELOFLEXX is mounted to the fork bridge with a rubberized hook-and-loop fastener or a cable tie. The black-coated stays provide even greater support. - Compatible only with disc brakes - Includes hook-and-loop fasteners and tension rubber
Shockboard / Shockblade & Dashboard hardware kit (for 2nd bike)
Addd an extra dose of stability to SKS's Velo 55 fenders. A stainless steel U-stay mounts to the fenders and your frame eyelets to eliminate rattling and bouncing fenders.
- Smart clip-on front mudguard for road, cyclocross, hybrid, gravel bikes, etc. - Fits a maximum tyre width up to 38mm. - It is the ideal companion to our S-BLADE rear mudguard. - Its smart, double hinged quick release fitting system also fits aero forks. - Paintwork protection film for the frame is included.
Say goodbye to flying mud! The SPEEDROCKER Extension clip-on mudguard extension mainly protects riders behind you from dirt and wet conditions. The extension—made of black, impact-resistant plastic—can be easily clipped onto the tried and tested SPEEDROCKER rear mudguard, thus extending it by 170mm. It can be mounted and removed without any tools in just a few seconds. The splashing between the tire and mudguard at the lower end also allows it to better deflect any spraying water and mud. This not only protects the rider's back, but also their cycling companion from any flying dirt. - Weight: 36g - Length rear fender: 170mm
No matter the conditions, stay dry and clean with SKS's X-Tra Dry rear fender! It's super light and nearly unbreakable so you know it's ready for the miles, on road and off. Plus, it works with most bikes thanks to its easy-to-adjust seatpost mounting strap.
- DAD Hardware kit, for 2nd bike, or to replace worn parts
- Raceblade Long Hardware Kit, for 2nd bike, or to replace worn parts
- Rubber straps - Fit Raceblade, Mud-x - Set of 8
Mudguard set for front and rear. – 45mm with fixed bridges – 3mm stainless steel stays – Front angle, sliding bridges, and fixed bridges made from stainless steel – Security fastening ASR joint, angle adjustable
This super-lightweight (45g) and discreet mudguard protects your face (and your fork seals) from mud and water. Made of super-soft material, it fits 26", 27.5", and 29" bikes and is compatible with most forks. Thanks to the included zip ties that wrap around the fork bridge and fork legs, the Flapguard sticks close to your bike even during extremely aggressive riding. - Also compatible on rear side of frame
Stay clean and dry with SKS's Velo42 Urban fenders! The rear snap-on fender attaches to seat tubes between 25 and 35mm in diameter to give you full coverage from road spray. These fenders fit tires up to 32mm wide.
Keep water and mud off you with SKS's Mud-X down tube fender! This versatile fender works with most bikes regardless of wheel size.
Keep water and mud at bay with SKS's Dashblade fender! It's light and easy to install and remove thanks to its quick-release strap that fits a wide variety of seatposts and seat tubes.
Addd an extra dose of stability to SKS's Velo 65 fenders. A stainless steel U-stay mounts to the fenders and your frame eyelets to eliminate rattling and bouncing fenders.
Addd an extra dose of stability to SKS's Velo 42 and Velo 47 fenders. A stainless steel U-stay mounts to the fenders and your frame eyelets to eliminate rattling and bouncing fenders.
Designed specifically for commuters, this 45mm wide front and rear fender set is the perfect option for the every day rider. The reflective strips that run down either side of the fenders provides enhanced visibility. - Sturdy stainless steel double stays - Easily mounted with included hardware
The X-Guard is a universal downtube fender for any wheel size. It is attached using two straps on the lower bar (downtube), making it compatible with fat bikes and bicycles with oversized tires for all-around mud protection. It also protects E-MTB batteries from dirt, splashes and flying rocks. The straps are extra long and can be shortened as needed, making X-Guard suitable for any frame shape and all common battery models.
Previous page Page 2 of 2